U2619 – CAN Bus Communication Failure

The ODBII code U2619 indicates a “CAN Bus Communication Failure,” which means there is a problem with the communication between the vehicle’s control modules over the Controller Area Network (CAN) bus.

The severity of ODBII code U2619 is moderate.

Common Causes For: U2617 U2617: “CAN Bus Communication Failure”

• Faulty CAN bus wiring or connectors
• Short circuit in the CAN bus
• Open circuit in the CAN bus
• Faulty control module
• Poor ground connection
• Interference from other electronic devices
• Corroded or damaged connectors
• Software issues or bugs in the control module
• Low battery voltage or power supply issues
• Faulty termination resistors

Common misdiagnosis for U2619 U2619: “CAN Bus Communication Failure”

• Faulty CAN Bus wiring
• Defective ECU (Electronic Control Unit)
• Malfunctioning sensors
• Poor ground connections
• Intermittent electrical connections
• Faulty diagnostic tools
• Software issues or updates needed
• Other communication protocol failures

Common Troubleshooting Steps

The OBD-II code U2619 indicates a “CAN Bus Communication Failure.” This code typically points to issues with the Controller Area Network (CAN) bus, which is responsible for communication between various electronic control units (ECUs) in a vehicle. Here are some common troubleshooting steps to diagnose and resolve the issue:

• Check for Additional Codes: Use an OBD-II scanner to check for any other related trouble codes. This can provide more context about the issue.
• Inspect the Wiring and Connectors: **Visual Inspection: Look for damaged, frayed, or corroded wires and connectors related to the CAN bus.
• **Loose Connections: Ensure that all connectors are securely attached and free of corrosion.
• Test the CAN Bus Voltage: Use a multimeter to check the voltage levels on the CAN High (CAN H) and CAN Low (CAN L) wires. The typical voltage levels should be around 2.5V when idle and should vary when data is being transmitted.
• Check for Short Circuits: Inspect the CAN bus wiring for any short circuits to ground or to other wires. This can cause communication failures.
• Inspect the ECUs: Check the individual ECUs connected to the CAN bus. A malfunctioning ECU can disrupt communication. If possible, disconnect each ECU one at a time to identify if one is causing the issue.
• Test the Termination Resistors: Ensure that the CAN bus has the correct termination resistors (typically 120 ohms) at both ends of the bus. A missing or faulty resistor can lead to communication issues.
• Check for Interference: Look for sources of electrical interference that may affect the CAN bus communication, such as aftermarket accessories or modifications.
• Scan for Software Updates: Check if there are any software updates available for the vehicle’s ECUs. Sometimes, communication issues can be resolved with a software update.
• Perform a Network Test: If available, use a specialized CAN bus diagnostic tool to perform a network test. This can help identify which ECU is not communicating properly.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the trouble codes and take the vehicle for a test drive to see if the code returns.1
• Consult a Professional: If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician with experience in automotive electronics and CAN bus systems. By following these troubleshooting steps, you can systematically identify and resolve the underlying issues causing the U2619 code.