U2630 – CAN Communication Bus Off.

The ODBII code U2630 indicates a fault in the CAN (Controller Area Network) communication bus, specifically that the bus is in a “Bus Off” state, meaning it has detected excessive errors and has stopped transmitting to prevent further issues.

The severity of ODBII code U2630 CAN Communication Bus Off is moderate to severe.

Common Causes For: U2629 Invalid Data Received from Vehicle Dynamics Control Module.

• Faulty CAN bus wiring or connectors
• Defective CAN bus module
• Short circuit in the CAN bus
• Open circuit in the CAN bus
• Interference from other electrical components
• Faulty or damaged ECU
• Poor ground connections
• Software issues or bugs in the ECU
• Low battery voltage or power supply issues
• Corroded or damaged terminals

Common misdiagnosis for U2630 CAN Communication Bus Off.

• Faulty Engine Control Module (ECM)
• Bad Wiring or Connectors
• Defective Body Control Module (BCM)
• Malfunctioning Transmission Control Module (TCM)
• Issues with the Powertrain Control Module (PCM)
• Battery or Charging System Problems
• Faulty Sensors
• Incorrectly Diagnosed Communication Issues with Other Modules

Common Troubleshooting Steps

The OBD-II code U2630 indicates a problem with the CAN (Controller Area Network) communication bus, specifically that the bus is “off.” This can lead to various issues with communication between different modules in the vehicle. Here are some common troubleshooting steps to diagnose and resolve the U2630 code:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. This can provide more context about the issue.
• Inspect the Wiring and Connectors: Visually inspect the wiring harnesses and connectors related to the CAN bus. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the connectors at the ECM (Engine Control Module) and other modules on the CAN bus.
• Test the CAN Bus Voltage: Use a multimeter to check the voltage levels on the CAN High and CAN Low wires. The typical voltage levels should be around 2.5V when the bus is idle.
• If the voltage levels are significantly off, there may be a short or open circuit.
• Check for Short Circuits: Inspect the CAN bus wiring for any short circuits to ground or to each other. This can cause the bus to go “off.”
• Examine the Modules: Check the individual modules on the CAN bus for proper operation. A malfunctioning module can cause communication issues.
• If possible, disconnect each module one at a time to see if the code clears or if communication is restored.
• Look for Interference: Ensure that there are no aftermarket devices or modifications that could be interfering with the CAN bus communication.
• Check the Termination Resistors: Verify that the CAN bus has the correct termination resistors (typically 120 ohms) at both ends of the bus. Missing or faulty resistors can lead to communication issues.
• Perform a Network Test: If available, use a professional scan tool to perform a network test. This can help identify which module is causing the communication failure.
• Clear the Codes and Test Drive: After performing the above checks and repairs, clear the trouble codes and take the vehicle for a test drive to see if the code returns.
• Consult Technical Service Bulletins (TSBs): Check for any TSBs related to the specific make and model of the vehicle. Manufacturers may have known issues and recommended fixes for the U2630 code.1
• Seek Professional Help: If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who specializes in automotive electronics. By following these troubleshooting steps, you should be able to identify and resolve the issue causing the U2630 code.