U2640 – Communication Bus Off.

The ODBII code U2640 indicates a communication issue where the vehicle’s communication bus is offline or not functioning properly, affecting data exchange between modules.

The severity of ODBII code U2640 Communication Bus Off is moderate to severe.

Common Causes For: U2634 Invalid Data Received from Vehicle Dynamics Control Module.

• Faulty communication module
• Damaged wiring or connectors
• Short circuit in the communication bus
• Open circuit in the communication bus
• Faulty ECU (Electronic Control Unit)
• Interference from aftermarket devices
• Low battery voltage
• Corroded connectors or terminals
• Software issues or bugs in the ECU
• Grounding issues

Common misdiagnosis for U2640 Communication Bus Off.

• Faulty wiring or connectors
• Defective control modules
• Battery or power supply issues
• Incorrectly diagnosed sensor failures
• Software or firmware issues
• Grounding problems
• Intermittent electrical connections
• Faulty communication lines or circuits

Common Troubleshooting Steps

The OBD-II code U2640 indicates a communication issue related to the CAN (Controller Area Network) bus, specifically that a device on the network is reporting a “Bus Off” condition. This typically means that a module on the network has detected a fault and has stopped communicating to prevent further issues. Here are some common troubleshooting steps to diagnose and resolve the U2640 code:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Other codes may provide more context about the issue.
• Inspect the Wiring and Connectors: Visually inspect the wiring and connectors related to the CAN bus. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the connectors at the ECM (Engine Control Module) and other modules on the CAN bus.
• Test the CAN Bus Voltage: Use a multimeter to check the voltage levels on the CAN High and CAN Low wires. The typical voltage levels should be around 2.5V when idle and should vary when data is being transmitted.
• If the voltage levels are outside the expected range, there may be a short or open circuit.
• Check for Short Circuits: Inspect the CAN bus wiring for any short circuits to ground or to each other. This can cause the bus to go “off.”
• Disconnect Modules: If you suspect a specific module is causing the issue, disconnect it from the CAN bus and see if the code clears. If it does, the module may be faulty.
• Check for Faulty Modules: If a specific module is suspected, test it for proper operation. This may involve checking for updates, reprogramming, or replacing the module.
• Inspect the Termination Resistors: Ensure that the CAN bus has the correct termination resistors (typically 120 ohms) at both ends of the bus. A missing or faulty resistor can cause communication issues.
• Scan for Software Updates: Check if there are any software updates available for the vehicle’s modules. Sometimes, communication issues can be resolved with a software update.
• Perform a Network Test: Use a professional scan tool capable of performing a network test to check the integrity of the CAN bus and identify any communication faults.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the trouble codes and take the vehicle for a test drive to see if the code returns.1
• Consult Technical Service Bulletins (TSBs): Check for any TSBs related to the U2640 code for your specific vehicle make and model. Manufacturers may have specific recommendations or known issues.1
• Seek Professional Help: If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who specializes in automotive electronics. By following these steps, you should be able to diagnose and potentially resolve the U2640 code. Always refer to the vehicle’s service manual for specific procedures and specifications.