U2740 – Invalid Data Received from Vehicle Control Module.

The ODBII code U2740 indicates that the vehicle’s control module has received invalid or corrupted data from another control module, leading to communication issues within the vehicle’s network.

The severity of ODBII code U2740 is generally considered moderate.

Common Causes For: U2739 Invalid Data Received from the Transmission Control Module (TCM)”.

• Faulty Vehicle Control Module (VCM)
• Poor or damaged wiring/connectors
• Corrupted software or firmware in the VCM
• Communication issues between modules
• Grounding issues
• Faulty sensors sending incorrect data
• Interference from aftermarket devices or modifications

Common misdiagnosis for U2740 Invalid Data Received from Vehicle Control Module.

• Faulty Vehicle Control Module (VCM)
• Wiring issues or shorts in the communication lines
• Faulty sensors or actuators
• Incorrectly configured or programmed modules
• Issues with the power supply to the VCM
• Corrupted software or firmware in the VCM
• Problems with the diagnostic connector or interface
• Intermittent connection issues due to corrosion or damage

Common Troubleshooting Steps

The OBD-II code U2740 indicates that there is an issue with the communication between the vehicle control module (VCM) and other modules in the vehicle. This code typically points to a problem with the data being received from the VCM, which can be caused by various factors. Here are some common troubleshooting steps to diagnose and resolve the issue:

• Check for Other Codes: Start by scanning the vehicle for any other diagnostic trouble codes (DTCs). Sometimes, related codes can provide additional context for the problem.
• Inspect Wiring and Connectors: Examine the wiring and connectors associated with the VCM and other modules. Look for signs of damage, corrosion, loose connections, or frayed wires. Repair or replace any damaged components.
• Check Power and Ground: Ensure that the VCM is receiving proper power and ground. Use a multimeter to check voltage and ground connections. If there are issues, trace the wiring back to the power source or ground point.
• Inspect the VCM: If the wiring and connections are intact, the issue may lie within the VCM itself. Check for any signs of physical damage or water intrusion. If necessary, consider reprogramming or replacing the VCM.
• Check for Software Updates: Sometimes, manufacturers release software updates for the VCM or other modules. Check with the manufacturer or a dealership to see if there are any updates available that could resolve communication issues.
• Test Other Modules: Since U2740 involves communication between modules, check other related modules for faults. Use a scan tool to communicate with each module and ensure they are functioning correctly.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the codes using a scan tool and take the vehicle for a test drive. Monitor for any reoccurrence of the U2740 code.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the U2740 code for your specific vehicle make and model. Manufacturers may have documented common issues and solutions.
• Professional Diagnosis: If the problem persists after performing the above steps, it may be necessary to seek the assistance of a professional mechanic or dealership with advanced diagnostic tools. By following these steps, you can systematically identify and resolve the underlying issue causing the U2740 code.