U2753 – Control Module Communication Bus Off.

The ODBII code U2753 indicates a communication issue where a control module is unable to communicate over the vehicle’s communication bus, often due to a fault in the module or wiring.

The severity of ODBII code U2753 is moderate to severe.

Common Causes For: U2751 Control Module Communication Bus Off.

• Faulty control module
• Poor electrical connections or wiring issues
• Short circuits in the communication lines
• Corroded connectors
• Faulty or damaged communication bus (CAN bus)
• Software or firmware issues in the control module
• Power supply problems to the control module
• Interference from aftermarket devices or modifications

Common misdiagnosis for U2753 Control Module Communication Bus Off.

• Faulty control module
• Wiring issues
• Poor ground connections
• Corrupted software/firmware
• Faulty sensors
• Battery or power supply issues
• Communication network problems
• Intermittent connection issues

Common Troubleshooting Steps

The OBD-II code U2753 indicates a communication issue on the control module communication bus, specifically that a control module is “off” or not responding. This can be caused by various issues, including wiring problems, module failures, or software issues. Here are some common troubleshooting steps to diagnose and resolve the U2753 code:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. This can provide more context about the issue.
• Inspect Wiring and Connectors: Visually inspect the wiring and connectors related to the control modules on the communication bus. Look for signs of damage, corrosion, or loose connections.
• Pay special attention to the ground connections, as poor grounding can lead to communication issues.
• Check Power Supply: Ensure that the control modules have the proper power supply. Use a multimeter to check voltage at the module connectors.
• Verify that fuses related to the control modules are intact.
• Test the Control Modules: If possible, test the affected control module(s) for functionality. This may involve using specialized diagnostic tools or swapping with a known good module.
• Check for any software updates or reprogramming that may be required for the control module.
• Inspect the Communication Bus: Check the integrity of the communication bus (CAN bus, LIN bus, etc.). Use an oscilloscope or a CAN bus analyzer to monitor the bus for proper signals.
• Look for short circuits, open circuits, or excessive resistance in the communication lines.
• Check for Interference: Ensure that there are no aftermarket devices or modifications that could be interfering with the communication bus.
• Clear Codes and Test Drive: After performing inspections and repairs, clear the trouble codes using the OBD-II scanner.
• Take the vehicle for a test drive to see if the code returns.
• Consult Technical Service Bulletins (TSBs): Check for any manufacturer-specific TSBs related to the U2753 code or communication issues. There may be known fixes or recalls.
• Seek Professional Help: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership with experience in diagnosing communication issues.Conclusion Troubleshooting OBD-II code U2753 requires a systematic approach to identify the root cause of the communication failure. By following these steps, you can narrow down the potential issues and work towards a resolution.