U2810 – Lost Communication with the Steering Angle Sensor.

The ODBII code U2810 indicates a loss of communication with the steering angle sensor, which may affect the vehicle’s stability control and steering functions.

The severity of ODBII code U2810 is generally considered moderate.

Common Causes For: U2808 U2808: Control Module Communication Bus Fault

• Faulty steering angle sensor
• Damaged wiring or connectors
• Poor electrical connections
• Malfunctioning power supply to the sensor
• Software issues or calibration errors
• Faulty vehicle control module (VCM)
• Interference from other electronic components

Common misdiagnosis for U2810 Lost Communication with the Steering Angle Sensor.

• Faulty Steering Angle Sensor
• Wiring Issues or Short Circuits
• Faulty Steering Column Module
• Malfunctioning Electronic Control Unit (ECU)
• Incorrectly Calibrated Steering Angle Sensor
• Issues with the Vehicle’s CAN Bus System
• Faulty ABS Module
• Power Supply Problems

Common Troubleshooting Steps

When dealing with the OBD-II code U2810, which indicates “Lost Communication with the Steering Angle Sensor,” there are several common troubleshooting steps you can follow to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Other codes may provide more context or indicate related issues.
• Inspect Wiring and Connectors: **Visual Inspection: Check the wiring harness and connectors associated with the steering angle sensor for any signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent, corroded, or pushed back.
• Test the Steering Angle Sensor: **Sensor Functionality: If possible, test the steering angle sensor using a multimeter or scan tool to ensure it is functioning correctly. Check the output voltage or signal as specified by the manufacturer.
• **Calibration: Some vehicles require the steering angle sensor to be calibrated after installation or repair. Refer to the vehicle’s service manual for calibration procedures.
• Check Power and Ground: **Power Supply: Verify that the steering angle sensor is receiving the correct voltage. Use a multimeter to check the power supply at the sensor connector.
• **Ground Connection: Ensure that the ground connection for the sensor is intact and has a good connection.
• Inspect the CAN Bus: **Communication Lines: Since the steering angle sensor communicates over the CAN bus, check for any issues with the CAN wiring. Look for shorts, opens, or interference in the communication lines.
• **CAN Bus Termination: Ensure that the CAN bus is properly terminated at both ends.
• Check for Software Issues: **ECU Updates: Sometimes, software updates for the vehicle’s ECU can resolve communication issues. Check with the manufacturer for any available updates.
• **Resetting the ECU: Disconnect the battery for a few minutes to reset the ECU and see if the code returns.
• Inspect Related Components: **Steering Column: Check for any issues with the steering column or related components that may affect the sensor’s operation.
• **Other Sensors: Inspect other sensors that may be related to the steering system, as issues with them can sometimes cause communication problems.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the steering angle sensor or communication issues for your specific vehicle make and model. Manufacturers may have known fixes for common problems.
• Professional Diagnosis: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have specialized tools and knowledge to diagnose the problem more effectively.Conclusion By following these troubleshooting steps, you can systematically identify and address the cause of the U2810 code. Always refer to the vehicle’s service manual for specific procedures and specifications related to your vehicle.