U2814 – Control Module Communication Failure

The ODBII code U2814 indicates a “Control Module Communication Failure,” meaning there is a problem with the communication between various control modules in the vehicle’s network.

The severity of ODBII code U2814 is moderate.

Common Causes For: U2813 U2813: BECM Communication Error – Invalid Data Received

• Faulty control module
• Poor electrical connections
• Damaged wiring harness
• Corroded connectors
• Software issues or bugs
• Low battery voltage
• Interference from aftermarket devices
• Faulty CAN bus communication
• Grounding issues
• Failed or malfunctioning sensors

Common misdiagnosis for U2814 U2814: “Control Module Communication Failure”

• Faulty control module
• Wiring issues
• Poor ground connections
• Corrupted software/firmware
• Faulty sensors
• Battery or power supply problems
• Intermittent connection issues
• Communication network faults (e.g., CAN bus issues)

Common Troubleshooting Steps

The OBD-II code U2814 indicates a “Control Module Communication Failure.” This code typically suggests that there is a problem with communication between various control modules in the vehicle. Here are some common troubleshooting steps to diagnose and resolve this issue:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Sometimes, other codes can provide context or lead to the root cause of the communication failure.
• Inspect Wiring and Connectors: **Visual Inspection: Check the wiring harnesses and connectors associated with the control modules for any signs of damage, corrosion, or loose connections.
• **Repair or Replace: Repair any damaged wires or connectors and ensure that all connections are secure.
• Check Power and Ground: **Power Supply: Verify that the control modules are receiving the correct voltage. Use a multimeter to check the power supply to the affected module.
• **Ground Connections: Ensure that all ground connections are clean and secure. Poor grounding can lead to communication issues.
• Inspect Control Modules: **Module Functionality: If possible, test the affected control module to ensure it is functioning correctly. This may involve swapping it with a known good module if available.
• **Software Updates: Check if there are any software updates available for the control modules. Sometimes, manufacturers release updates to fix communication issues.
• Check for Interference: **Aftermarket Accessories: If any aftermarket accessories (like alarms, radios, etc.) have been installed, they may interfere with communication. Temporarily disconnect them to see if the issue resolves.
• **Environmental Factors: Ensure that there are no environmental factors (like moisture or extreme temperatures) affecting the control modules.
• Perform a Network Test: Use a scan tool capable of performing a network test to check the communication between modules. This can help identify which module is not communicating properly.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the trouble codes using the OBD-II scanner and take the vehicle for a test drive to see if the code reappears.
• Consult Technical Service Bulletins (TSBs): Check for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued bulletins regarding known issues and fixes for communication failures.
• Seek Professional Help: If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or dealership for further diagnosis. They may have specialized tools and knowledge to address complex communication issues. By following these troubleshooting steps, you can systematically identify and resolve the underlying cause of the U2814 code.