U2960 – Lost Communication with the Hybrid Powertrain Control Module (HPCM) A.

The ODBII code U2960 indicates a loss of communication with the Hybrid Powertrain Control Module (HPCM) A, suggesting that the vehicle’s diagnostic system is unable to communicate with this specific module, which may affect hybrid system performance.

The severity of ODBII code U2960 is typically considered moderate to severe.

Common Causes For: U2959 Lost Communication with Vehicle Control Module.

• Faulty Hybrid Powertrain Control Module (HPCM)
• Damaged or corroded wiring or connectors
• Poor ground connections
• Communication network issues (CAN bus problems)
• Faulty or disconnected sensors
• Software or firmware issues
• Battery or power supply problems

Common misdiagnosis for U2960 Lost Communication with the Hybrid Powertrain Control Module (HPCM) A.

• Faulty Hybrid Powertrain Control Module (HPCM)
• Wiring issues or damaged connectors
• Faulty Engine Control Module (ECM)
• Battery management system problems
• Communication network issues (CAN bus)
• Faulty sensors related to the hybrid system
• Power supply issues to the HPCM
• Software or firmware issues in the HPCM or ECM

Common Troubleshooting Steps

When dealing with the OBD-II code U2960, which indicates “Lost Communication with the Hybrid Powertrain Control Module (HPCM) A,” there are several common troubleshooting steps you can follow to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Other Codes: Use an OBD-II scanner to check for any additional trouble codes. Sometimes, related codes can provide more context for the issue.
• Inspect the Wiring and Connectors: **Visual Inspection: Check the wiring harness and connectors related to the HPCM for any signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent, corroded, or damaged.
• Check Power and Ground: **Power Supply: Verify that the HPCM is receiving the correct voltage. Use a multimeter to check the power supply to the module.
• **Ground Connections: Ensure that the ground connections for the HPCM are secure and free of corrosion.
• Inspect the HPCM: **Module Condition: If possible, check the HPCM for any visible signs of damage or failure.
• **Reprogramming: In some cases, the module may need to be reprogrammed or updated with the latest software.
• Check Communication Lines: **CAN Bus: Inspect the Controller Area Network (CAN) bus lines for continuity and integrity. Look for shorts, opens, or high resistance in the communication lines.
• **Scan Tool Communication: Use a scan tool to check if you can communicate with the HPCM. If you cannot, it may indicate a problem with the module or the communication lines.
• Test the HPCM: If you have access to a known good HPCM, consider swapping it out to see if the issue persists. This can help determine if the module itself is faulty.
• Check for Environmental Factors: Ensure that there are no environmental factors affecting the HPCM, such as water intrusion or excessive heat.
• Clear Codes and Test Drive: After performing the above checks and repairs, clear the trouble codes and take the vehicle for a test drive to see if the code returns.
• Consult Technical Service Bulletins (TSBs): Check for any TSBs related to the specific make and model of the vehicle. Manufacturers may have issued guidance on common issues related to the HPCM.
• Seek Professional Help: If the issue persists after performing these steps, it may be necessary to consult a professional mechanic or technician who specializes in hybrid vehicles for further diagnosis. By following these steps, you can systematically approach the troubleshooting of the U2960 code and identify the root cause of the communication issue with the HPCM.