U2968 – Lost Communication with the Hybrid Powertrain Control Module (HPCM) A.

The ODBII code U2968 indicates that there is a loss of communication with the Hybrid Powertrain Control Module (HPCM) A, which may affect the vehicle’s hybrid system functionality.

The severity of ODBII code U2968 is typically considered moderate to severe.

Common Causes For: U2967 Lost Communication with the Hybrid Powertrain Control Module (HPCM) A.

• Faulty Hybrid Powertrain Control Module (HPCM)
• Damaged or corroded wiring or connectors
• Poor ground connections
• Failed communication network (CAN bus issues)
• Blown fuses
• Software or firmware issues
• Battery or power supply problems

Common misdiagnosis for U2968 Lost Communication with the Hybrid Powertrain Control Module (HPCM) A.

• Faulty wiring or connectors
• Defective Hybrid Powertrain Control Module (HPCM)
• Issues with the Engine Control Module (ECM)
• Battery or power supply problems
• Faulty sensors related to the hybrid system
• Communication issues with other control modules
• Software or firmware issues in the HPCM or ECM

Common Troubleshooting Steps

When dealing with the OBD-II code U2968, which indicates “Lost Communication with the Hybrid Powertrain Control Module (HPCM) A,” there are several common troubleshooting steps you can follow to diagnose and potentially resolve the issue. Here’s a structured approach:

• Check for Additional Codes: Use an OBD-II scanner to check for any other trouble codes that may be present. This can provide more context and help identify related issues.
• Inspect the Wiring and Connectors: **Visual Inspection: Check the wiring harness and connectors related to the HPCM for any signs of damage, corrosion, or loose connections.
• **Connector Pins: Ensure that the pins in the connectors are not bent, corroded, or damaged.
• Check Power and Ground: **Power Supply: Verify that the HPCM is receiving the correct voltage. Use a multimeter to check the power supply to the module.
• **Ground Connections: Ensure that the ground connections for the HPCM are secure and free of corrosion.
• Inspect the HPCM: If accessible, check the HPCM for any physical damage or signs of overheating.
• If possible, test the HPCM with a known good unit to see if the issue persists.
• Check Communication Lines: Use a scan tool to monitor communication between the HPCM and other modules. Look for any interruptions or failures in communication.
• Check the CAN (Controller Area Network) bus for faults. This may involve using an oscilloscope to check for proper signal levels.
• Perform a Hard Reset: Disconnect the vehicle’s battery for a few minutes to reset the modules. Reconnect and see if the code reappears.
• Software Updates: Check if there are any software updates available for the HPCM or other related modules. Sometimes, communication issues can be resolved with a software update.
• Scan Tool Functionality: Ensure that the scan tool being used is compatible with the vehicle and can communicate with all modules. Some generic scanners may not access all manufacturer-specific codes.
• Consult Technical Service Bulletins (TSBs): Look for any TSBs related to the HPCM or communication issues for your specific vehicle make and model. Manufacturers may have known fixes for common problems.
• Professional Diagnosis: If the issue persists after performing the above steps, consider seeking help from a professional mechanic or dealership. They may have specialized tools and knowledge to diagnose complex communication issues.Conclusion Troubleshooting OBD-II code U2968 involves a systematic approach to check for wiring issues, power supply, communication integrity, and module functionality. Following these steps can help identify the root cause of the communication loss with the Hybrid Powertrain Control Module.