Dome Light Bulb Replacement Cost Guide
Standard Dome Light Bulb
Labor Time: 15-20 minutes
Labor Cost: $31.25 - $41.67
Parts Cost: $5-$15
Total Estimated Cost: $36.25 - $56.67
LED Dome Light Assembly
Labor Time: 20-30 minutes
Labor Cost: $41.67 - $62.50
Parts Cost: $25-$75
Total Estimated Cost: $66.67 - $137.50
Map/Reading Light Assembly
Labor Time: 25-35 minutes
Labor Cost: $52.08 - $72.92
Parts Cost: $20-$60
Total Estimated Cost: $72.08 - $132.92
*Note: Prices are estimates based on our standard rate of $125/hour. Actual costs may vary depending on vehicle make, model, and year. Some luxury vehicles may require special parts that could increase costs.
Additional Considerations:
- Diagnostic time may be required for electrical issues
- Multiple bulb replacements can be more cost-effective when done together
- Warranty coverage may apply for newer vehicles
Dome Light Bulb Repair Procedures
Standard Dome Light Bulb
Tools needed:Flathead screwdriver, replacement bulb
Repair steps:
- Locate the small notch or slot on the dome light cover
- Carefully pry off the plastic cover using a flathead screwdriver
- Remove the old bulb by gently pulling or twisting it out (depending on model)
- Insert the new bulb, ensuring proper alignment
- Test the light before replacing the cover
- Snap the cover back into place
LED Dome Light
Tools needed:Flathead screwdriver, replacement LED module
Repair steps:
- Remove the dome light cover as described above
- Disconnect the wiring harness from the LED module
- Remove any mounting screws securing the LED module
- Install the new LED module
- Reconnect the wiring harness
- Test the light before reassembly
- Replace the cover
Map Light/Dual Dome Light
Tools needed:Flathead screwdriver, replacement bulb(s)
Repair steps:
- Remove the entire light assembly cover
- Identify which bulb needs replacement
- Remove the faulty bulb(s) by gently pulling or twisting
- Insert new bulb(s) in the correct orientation
- Test all lights in the assembly
- Reattach the cover assembly
Important Notes:
- Always check your vehicle's manual for specific bulb types
- Handle new bulbs with clean hands or gloves
- Never force components as this may cause damage
- If unsure, consult a professional mechanic
Note: These procedures may vary depending on your vehicle's make and model. Some vehicles may require additional steps or specialized tools.
Types of Dome Light Bulbs
No content available for this section.
Common Failure Symptoms of Dome Light Bulbs
Signs of Dome Light Bulb Failure & Maintenance Guide
Incandescent Dome Light Bulbs
Signs of Failure:
- Sudden complete failure (bulb burns out)
- Flickering before complete failure
- Dimming light output
- Discoloration of the glass bulb
Service Schedule:
Typically needs replacement every 500-1,000 hours of use or approximately every 2-3 years under normal usage. No maintenance required besides replacement.
LED Dome Light Bulbs
Signs of Failure:
- Gradual dimming over time
- Individual LED segments failing
- Color shifting (usually becoming more yellow)
- Intermittent operation
Service Schedule:
LED dome lights typically last 25,000-50,000 hours. Most users will never need to replace them during vehicle ownership. No regular maintenance required.
Halogen Dome Light Bulbs
Signs of Failure:
- Sudden burnout
- Filament breaking
- Light appears more orange than usual
- Clouding of the glass envelope
Service Schedule:
Replace every 2,000-4,000 hours of use or approximately every 3-4 years. Handle with care during replacement as oils from skin can cause premature failure.
Xenon Dome Light Bulbs
Signs of Failure:
- Slow start-up or delayed illumination
- Pink or purple color shift
- Flickering during operation
- Requires multiple attempts to turn on
Service Schedule:
Replace every 10,000-15,000 hours or when signs of failure appear. Professional installation recommended due to high voltage requirements.
Note: All replacement intervals are approximate and may vary based on usage patterns and environmental conditions.
How It Works
- Get a quote online or set-up a time to have your vehicle looked at.
- Pick time slots that work for you, easily, online.
- We will confirm appointments and send reminders.
- Our mechanics bring everything that is needed to you.
- All you have to do is provided a safe area for the work to be performed.
What we need from you
- A safe place to work on your vehicle
- No working on the side of busy roads
- No working on unstable or steep surfaces.
- We do not perform repairs during severe weather.
- Authorization from a property owner or management.
- Repair work done in a parking lot or at your requires permission.
- We do not do repairs in areas restricted by law.
Common Questions
Service Area
Our primary service area is greater Grand Rapids and includes Comstock Park, East Grand Rapids, Grandville, Kentwood, Walker, and Wyoming
Our secondary service area is provided by our Belding location and includes: Belding, Greenville, Ionia and the sorrounding areas.
Contact us if you have any questions about where we provide services.
