105,000 Mile Maintenance Service Cost Breakdown
At the 105,000-mile mark, your vehicle requires several important maintenance services. Here's a detailed cost breakdown based on our shop rate of $125/hour:
Oil and Filter ChangeLabor: 0.5 hours ($62.50)
Parts: $35-50
Total: $97.50-112.50
Labor: 0.5 hours ($62.50)
Total: $62.50
Labor: 0.3 hours ($37.50)
Parts: $40-60
Total: $77.50-97.50
Labor: 0.5 hours ($62.50)
Total: $62.50
Labor: 1.0-2.0 hours ($125-250)
Parts: $60-120
Total: $185-370
Labor: 1.0 hours ($125)
Parts/Fluid: $100-150
Total: $225-275
Labor: 1.0 hours ($125)
Parts/Fluid: $80-100
Total: $205-225
Note: Prices may vary based on vehicle make/model and any additional repairs needed. This is an estimate for typical services at 105,000 miles.
*Additional services may be recommended based on vehicle inspection and manufacturer specifications. All prices are estimates and subject to change.
105,000 Mile Maintenance Service Details
At 105,000 miles, your vehicle requires several important maintenance procedures to ensure optimal performance and longevity. Here's what our certified technicians will perform:
Engine Services
Oil and Filter Change:
- Drain existing oil completely
- Replace oil filter with OEM-quality replacement
- Refill with manufacturer-recommended grade oil
- Reset oil life monitor system
Spark Plug Replacement:
- Remove engine covers as needed
- Extract old spark plugs
- Gap and install new spark plugs to specification
- Inspect ignition coils for wear
Fluid Services
Brake Fluid Service:
- Test existing brake fluid for contamination
- Flush old brake fluid from system
- Refill with fresh DOT-specified brake fluid
- Bleed brake system to remove air
Coolant Service:
- Pressure test cooling system
- Drain old coolant
- Flush system to remove contaminants
- Refill with appropriate mixture of coolant and distilled water
Filters and Belts
Air Filter Replacement:
- Remove and inspect air filter housing
- Clean housing of debris
- Install new air filter
- Check for proper seating and seal
Drive Belt Inspection:
- Check all belts for wear and proper tension
- Replace serpentine belt if needed
- Inspect all pulleys and tensioners
- Adjust belt tension as necessary
Brake System
Brake Inspection:
- Measure brake pad thickness
- Inspect rotors for wear and warping
- Check brake line condition
- Test brake pedal feel and response
Additional Inspections
Comprehensive Vehicle Inspection:
- Check all exterior lights
- Inspect windshield wipers and washer operation
- Test battery condition and charging system
- Examine tire condition and adjust pressure
- Rotate tires as needed
- Check suspension components
- Verify proper operation of all safety systems
Note: Specific services may vary based on your vehicle's make, model, and manufacturer recommendations. Additional repairs may be recommended based on inspection findings.
Why Would I Need a 105,000 Mile Scheduled Maintenance
No content available for this section.
105,000 Mile Maintenance Service Guide
Engine Oil and Filter Change
Signs of Failure: Dark, dirty oil; engine knocking; decreased performance; check engine light
Service Schedule: Every 5,000-7,500 miles or as recommended by manufacturer
Tire Rotation and Balance
Signs of Failure: Uneven tire wear; vehicle vibration; pulling to one side
Service Schedule: Every 5,000-7,500 miles
Brake System Inspection
Signs of Failure: Squealing or grinding noise; soft brake pedal; longer stopping distance; vibration when braking
Service Schedule: Full inspection every 15,000-20,000 miles; replacement as needed
Transmission Fluid Service
Signs of Failure: Delayed shifting; grinding sounds; burning smell; slipping transmission
Service Schedule: Every 30,000-60,000 miles depending on vehicle make/model
Air and Fuel Filters
Signs of Failure: Decreased fuel efficiency; rough idling; starting problems; reduced engine performance
Service Schedule: Air filter every 15,000-30,000 miles; fuel filter every 20,000-40,000 miles
Spark Plugs
Signs of Failure: Rough idle; misfiring; hard starting; increased fuel consumption
Service Schedule: Every 60,000-100,000 miles for platinum plugs
Coolant System Service
Signs of Failure: Engine overheating; sweet smell from engine; low coolant levels; visible leaks
Service Schedule: Flush and replace every 60,000 miles
Power Steering Fluid
Signs of Failure: Whining noise when turning; stiff steering; fluid leaks
Service Schedule: Check every 15,000 miles; replace as needed
Belt and Hose Inspection
Signs of Failure: Squealing sounds; visible cracks; fraying; coolant leaks
Service Schedule: Inspect every 15,000 miles; replace timing belt at 90,000-100,000 miles
Suspension Components
Signs of Failure: Excessive bouncing; uneven tire wear; noise when going over bumps
Service Schedule: Inspect every 15,000-30,000 miles; replace as needed
Note: These intervals are general guidelines. Please consult your vehicle's owner's manual for specific maintenance schedules, as they may vary by make and model.
How It Works
- Get a quote online or set-up a time to have your vehicle looked at.
- Pick time slots that work for you, easily, online.
- We will confirm appointments and send reminders.
- Our mechanics bring everything that is needed to you.
- All you have to do is provided a safe area for the work to be performed.
What we need from you
- A safe place to work on your vehicle
- No working on the side of busy roads
- No working on unstable or steep surfaces.
- We do not perform repairs during severe weather.
- Authorization from a property owner or management.
- Repair work done in a parking lot or at your requires permission.
- We do not do repairs in areas restricted by law.
Common Questions
Service Area
Our primary service area is greater Grand Rapids and includes Comstock Park, East Grand Rapids, Grandville, Kentwood, Walker, and Wyoming
Our secondary service area is provided by our Belding location and includes: Belding, Greenville, Ionia and the sorrounding areas.
Contact us if you have any questions about where we provide services.
