Power Steering Cut Off Switch Repair Costs
Basic Switch Replacement
Labor Time: 0.5-1 hour
Parts Cost: $30-75
Total Estimated Cost: $92-200
Steering Column Switch Assembly
Labor Time: 1.5-2 hours
Parts Cost: $150-300
Total Estimated Cost: $337-550
Electronic Power Steering Switch
Labor Time: 1-1.5 hours
Parts Cost: $200-400
Total Estimated Cost: $325-587
Hydraulic Power Steering Switch
Labor Time: 1-2 hours
Parts Cost: $75-150
Total Estimated Cost: $200-400
Note: Prices may vary based on vehicle make, model, and year. Additional costs may apply if related components need replacement. All estimates include our standard labor rate of $125/hour.
Common Additional Services:
- Power steering fluid flush: $80-120
- Steering system diagnostic: $125
- Wiring harness repair: $150-300
Power Steering Cut Off Switch Repair Procedures
GM/Chevrolet Vehicles
Common Symptoms:Loss of power steering assist at low speeds or when stopped
Repair Steps:
- Locate the power steering cut off switch (typically near the steering column or under the dash)
- Disconnect the vehicle's battery
- Remove the lower dash panel or steering column cover
- Unplug the electrical connector from the switch
- Remove mounting screws/bolts securing the switch
- Install new switch in reverse order
- Reconnect battery and test operation
Ford Vehicles
Common Symptoms:Intermittent power steering loss, warning lights on dash
Repair Steps:
- Access the switch through the engine compartment (usually mounted on firewall)
- Disconnect battery
- Remove protective covers if present
- Disconnect electrical connections
- Remove mounting hardware
- Replace switch with new unit
- Reconnect all components
- Clear any diagnostic codes
Chrysler/Dodge Vehicles
Common Symptoms:Complete loss of power steering, electrical system warnings
Repair Steps:
- Locate switch near the steering gear or pump
- Disconnect battery
- Remove necessary components for access
- Label and disconnect electrical connections
- Remove switch mounting hardware
- Install new switch
- Reconnect all components
- Perform system reset if required
Important Notes:
- Always use OEM or high-quality replacement parts
- Verify proper electrical connections before completing repair
- Test steering system thoroughly after repair
- Some vehicles may require computer programming after switch replacement
Note: Specific procedures may vary by make, model, and year. Always consult your vehicle's service manual for exact specifications and procedures.
Understanding Power Steering Cut Off Switches
No content available for this section.
Common Failure Symptoms of Power Steering Cut-Off Switch
Power Steering Cut Off Switch: Signs of Failure & Maintenance Guide
Common Signs of Failure
1. Intermittent Power Steering Loss
One of the most common symptoms is random loss of power steering assistance while driving, especially during low-speed maneuvers.
2. Warning Light Activation
The power steering warning light on your dashboard may illuminate when the cut off switch begins to fail.
3. Inconsistent Steering Feel
You might notice the steering feels heavy at times and then suddenly becomes lighter, indicating the switch is failing to maintain consistent power steering operation.
4. Electrical Issues
Since the cut off switch is an electrical component, you might notice other electrical issues in the power steering system when it's failing.
Maintenance Schedule
Regular Inspection:
The power steering cut off switch should be inspected during routine maintenance checks, typically every 30,000 miles or 2 years, whichever comes first.
Testing Schedule:
- Basic functionality test during annual vehicle inspection
- Electrical connectivity check every 50,000 miles
- Physical inspection for corrosion or damage every 2 years
Replacement Guidelines:
While there's no set replacement interval, most manufacturers recommend:
- Preventive replacement every 100,000 miles
- Immediate replacement if any failure symptoms appear
- Replacement if physical damage or corrosion is detected
Note: These are general guidelines. Specific maintenance schedules may vary by vehicle make and model. Always consult your vehicle's manual or a certified technician for exact maintenance requirements.
How It Works
- Get a quote online or set-up a time to have your vehicle looked at.
- Pick time slots that work for you, easily, online.
- We will confirm appointments and send reminders.
- Our mechanics bring everything that is needed to you.
- All you have to do is provided a safe area for the work to be performed.
What we need from you
- A safe place to work on your vehicle
- No working on the side of busy roads
- No working on unstable or steep surfaces.
- We do not perform repairs during severe weather.
- Authorization from a property owner or management.
- Repair work done in a parking lot or at your requires permission.
- We do not do repairs in areas restricted by law.
Common Questions
Service Area
Our primary service area is greater Grand Rapids and includes Comstock Park, East Grand Rapids, Grandville, Kentwood, Walker, and Wyoming
Our secondary service area is provided by our Belding location and includes: Belding, Greenville, Ionia and the sorrounding areas.
Contact us if you have any questions about where we provide services.
