Headlamp Alignment Adjustment Costs
Basic Headlamp Alignment Check and Adjust
Labor Time: 0.5 hours
Typical Cost: $62.50
Includes basic inspection and adjustment of both headlamps using professional alignment equipment.
Headlamp Alignment with Mount/Hardware Inspection
Labor Time: 0.75 - 1.0 hours
Typical Cost: $93.75 - $125
Includes detailed inspection of mounting hardware, brackets, and adjustment mechanisms, plus alignment of both headlamps.
Complex Headlamp Alignment (Adaptive/LED Systems)
Labor Time: 1.0 - 1.5 hours
Typical Cost: $125 - $187.50
Required for vehicles with advanced lighting systems, including calibration of sensors and computer-controlled components.
Please Note:These are estimated costs based on our shop rate of $125/hour. Additional costs may apply if replacement parts are needed or if underlying issues are discovered during inspection.
Prices may vary depending on vehicle make, model, and year. Contact us for a specific quote for your vehicle.
Headlamp Alignment Adjustment Procedure
Preparation Steps:
- Park vehicle on level ground
- Ensure proper tire pressure
- Clear any heavy items from trunk/cargo area
- Ensure fuel tank is at least half full
- Have someone sit in driver's seat to simulate driving weight
Setting Up the Work Area:
- Position vehicle 25 feet from a flat wall or garage door
- Clean headlight lenses thoroughly
- Mark the horizontal centerline of headlights on the wall
- Mark the vertical centerlines for each headlight
Adjustment Process:
- Locate the headlight adjustment screws (typically two per headlight)
- Vertical adjustment screw
- Horizontal adjustment screw
- Turn on low beam headlights
- Cover one headlight while adjusting the other
- Adjust vertical alignment
- Beam should be slightly below horizontal mark
- Most manufacturers specify 2-4 inches below centerline
- Adjust horizontal alignment
- Bright spot should align with vertical centerline
- Ensure beam isn't pointing too far left or right
- Repeat process for other headlight
Final Verification:
- Check both headlights together
- Verify symmetrical alignment
- Test both low and high beams
- Ensure all adjustment screws are tight
Note: Some vehicles may require special tools or have different adjustment mechanisms. Consult your vehicle's manual for specific instructions. If you're unsure, it's best to have this service performed by a professional technician.
Professional Service Benefits:
- Precise alignment using specialized equipment
- Proper adjustment according to manufacturer specifications
- Ensures compliance with local regulations
- Saves time and prevents potential mistakes
Understanding Headlamp Alignment Adjustment
No content available for this section.
Common Symptoms of Faulty Headlamp Alignment Adjustment
Headlamp Alignment Service Guide
Signs Your Headlights Need Alignment:
Uneven Road Illumination
If one headlight appears to be pointing higher or lower than the other, or if you notice irregular light patterns on the road, this indicates misalignment.
Excessive Glare for Oncoming Traffic
When other drivers frequently flash their high beams at you, even though you're using regular beams, your headlights may be aimed too high.
Poor Visibility While Driving
If you're experiencing reduced visibility, especially at night, despite having clean and functional headlight bulbs, misalignment could be the cause.
Recent Incidents That May Affect Alignment:
- After a front-end collision
- Following suspension work
- After replacing headlight assemblies
- Heavy impact from potholes or curbs
Recommended Service Schedule:
Regular Maintenance:
Headlight alignment should be checked annually during routine maintenance inspections.
Specific Circumstances:
- Immediately after replacing headlight assemblies
- Following any front-end collision repairs
- When suspension components are replaced
- If you notice any signs of misalignment
Professional Recommendation:
While some vehicles allow for DIY adjustment, professional alignment ensures proper beam pattern and compliance with local regulations. Most manufacturers recommend professional inspection and adjustment for optimal safety and performance.
How It Works
- Get a quote online or set-up a time to have your vehicle looked at.
- Pick time slots that work for you, easily, online.
- We will confirm appointments and send reminders.
- Our mechanics bring everything that is needed to you.
- All you have to do is provided a safe area for the work to be performed.
What we need from you
- A safe place to work on your vehicle
- No working on the side of busy roads
- No working on unstable or steep surfaces.
- We do not perform repairs during severe weather.
- Authorization from a property owner or management.
- Repair work done in a parking lot or at your requires permission.
- We do not do repairs in areas restricted by law.
Common Questions
Service Area
Our primary service area is greater Grand Rapids and includes Comstock Park, East Grand Rapids, Grandville, Kentwood, Walker, and Wyoming
Our secondary service area is provided by our Belding location and includes: Belding, Greenville, Ionia and the sorrounding areas.
Contact us if you have any questions about where we provide services.
